Artifact Details


Whirlwind vacuum tube module rack

Catalog Number



Physical object



Identifying Numbers

Other number E14-12 Written in ball point pen on a paper sticker attached to the back of the left end of the upper channel.
Serial number 453 Stamped in white ink on the left end of the upper channel of the rack.


overall: 7 3/8 in x 26 in x 12 1/2 in


The rack is built around two identical frame members consisting of a piece of heavy metal that is bent up along one side and down along the other, resulting in an 'N'-shaped channel with a 1.75" bend up, a 2.25" horizontal surface, and a 0.625" bend down. Two of these, oriented in opposite directions, are held together with ten 24-contact edge connectors into which two-tube modules are inserted. Two 11-position screw terminal strips also span the two channels on the right side of the front. Twenty round holes to accommodate BNC connectors are drilled along the front of both channels; however, not all the holes are populated. On the back of the rack, phenolic boards with several rows of solder terminals are mounted to the horizontal sections of each channel, and another phenolic board with two rows of solder terminals is mounted perpendicular to the bottom one. Two 5-position screw terminal strips are mounted on the left side of the back of the rack, and one 4-position screw terminal strip is mounted to the bottom of the left end of the bottom channel.

About 7 long bus wires are connected to pins of the module sockets to supply common signals and voltages. The two horizontal boards are also wired with two busses each. The vertical board attached to the bottom horizontal board is intended to hold the passive components of the rack, but in this case there are no passive components. Wiring is point-to-point between the solder posts of the boards and the terminals of the module sockets. Some of the wiring terminates at the screw terminal strips. Many of the external wires connected to the screw terminal strips have been cut.

There are four BNC connectors in the 20 holes along the top of the rack; three of these have a BNC tee and a termination connected, the other has nothing attached. Four of the holes along the bottom of the rack are populated with BNC connectors. They each have a BNC tee, a terminator, and a short, intact BNC cable attached.

The eight module locations on the right are occupied by 2-tube plug-in modules, and they each have a tag attached with handwriting in pencil. The module model, serial number, and tag inscription are, from left to right: EDGG# 33, "E14-12-3"; DC CF III 21, "E14-12-4"; DGG# 16, "E14-12-5"; DC CF III 20, "E14-12-6"; EDGG 28, "E14-12-7"; DC CF III 23, "E14-12-8"; EDGG 2, "E14-12-9"; and DC CF III 24, "E14-12-10".




Gift of Compaq Computer Corporation

Lot Number