This is a gray flat ribbon cable of 60 inches with a male connector assembly on one side and a matching male connector assembly on the other. Each connector assembly has a connector with a 4 x 11 staggered array of pins soldered to a printed circuit board. The printed circuit board has a black anodized protective panel covering the back, and a smaller panel on the front that are screwed together to clamp the flat cable. There are two thumb screws protruding from the back use to clamp the connector to its mating connector. There are also two holes of approximately .5 inch diameter in the protective panel with matching holes in the PC board at opposite corners of the connector.
Date
unknown
Manufacturer
Diablo Systems, Inc.
Place Manufactured
Hayward, CA
Identifying Numbers
Model number
30
Printed on label on the back of the male-side mounting panel
Other number
11102
In the etch of the female-side PC-board
Part number
11100
In the etch of the female-side PC-board
Part number
11245-60
Printed on label on the back of the male-side mounting panel