TitleCRT monitor, 18-inch
Place ManufacturedU. S.
|Model number||GDM-1962B||Printed on the metal plate on the back of the monitor.|
|Other number||0014698-9204DX0773||Printed in black ink, along with a bar code, on a white label attached to the lower center of the back.|
|Other number||1971614||Written with felt tip pen on the orange packing slip envelope on top of the monitor.|
|Other number||244VC7||Labeled 'Service Code' and printed on the metal plate on the back of the monitor.|
|Other number||3651112-01||Printed in black ink, along with a bar code, on a white label attached to the lower center of the back.|
|Other number||4-032-673-01||Printed in the lower right corner of the metal plate on the back of the monitor.|
|Other number||PDU 11 26||Typed on a red, round sticker attached to the lower right corner of the front of the monitor.|
Dimensionsoverall: 19 1/2 in x 19 in x 21 in
DescriptionThis object is a typical CRT monitor mounted on swivel base; it does not tilt.
The height and width of the front section of the monitor are about 2" larger than the rear part; the rear section tapers from 15.25" wide in the front to 14.25" in the back and 12.5" deep in the front to 11.5" deep in the back. Each side has two narrow rows of slotted openings, one running along near the top and one along near the bottom. Most of the top and bottom surfaces of the rear section are covered with continuous slotted openings.
On the back surface of the monitor there is an IEC connector for power, D-connector with three coaxial connectors and 10 standard female contacts, and a small slide switch.
An orange 'Packing List Enclosed' envelope is stuck to the top of the front section of the monitor.