Artifact Details

Description

The rack is built around a rectangular, vertically mounted chassis constructed from four pieces of heavy metal riveted together, leaving a large rectangular hole in the center. To one side of this frame are two "Z" shaped channels whose narrow leg is riveted to the edge of the chassis and whose wide opposite leg is supported by standoffs at the upper and lower corners. Terminal strips mounted on pieces of fiberglass and 17 24-contact connectors span across the two channels. Seventeen 6-tube modules plug into these connectors and are held in place by lock screws on each side.

On the other (back side), mounted to each channel, is a phenolic terminal board that holds buses for power and signals common to all modules. Along the left side, mounted toward the outer edge of the channel, is a piece of "U" shaped metal that holds a BNC connector, one for each module. A continuous screw terminal strip occupies the same location on the right side of the chassis.

Connections among the connector terminals are made by point-to-point wiring; there are no passive components.

Each plug-in module is labeled "PUNCH MAGNET DRIVER" with a serial number and holds six miniature vacuum tubes protected against vibration by spring-loaded clamps. A paper tag attached to the handle of each module appears to identify specific module.

An engraved plastic label attached to the bottom of the back of the chassis reads "PLUG UNIT MTG PANEL, PUNCH MAGNET DRIVER."

Date

1951

Identifying Numbers

Other number	TO-05	Written with white grease pencil on the bottom of the rack.
Other number	WRDC Nonr 2956(00)-0009	Stamped in white ink at the top of the rack.
Serial number	1	Engraved on a piece of plastic on the back lower end of the chassis.

Dimensions

overall: 45 1/2 in x 13 1/4 in x 12 1/2 in

Category

Component/module